Configuring Services; Chapter 23 Configuring Services; Configuring Adaptive Services Pics (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

CHAPTER 23

Configuring Services

Configuring Adaptive Services PICs (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Configuring Adaptive Services PICs (NSM Procedure) on page 431
Configuring Border Signaling Gateways (NSM Procedure) on page 432
Configuring Class of Service (NSM Procedure) on page 451
Configuring Intrusion Detection Service (NSM Procedure) on page 454
Tracing Services PIC Operations (NSM Procedure) on page 458
Configuring Network Address Translation (NSM Procedure) on page 459
Configuring PGCP (NSM Procedure) on page 463
Configuring Service Interface Pools (NSM Procedure) on page 493
Configuring a Service Set (NSM Procedure) on page 494
Configuring Stateful Firewall (NSM Procedure) on page 498
Configuring Captive Portal (NSM Procedure) on page 500
Configuring Mobile IP (NSM Procedure) on page 505
Configuring RPM (NSM Procedure) on page 515
Configuring Unified Access Control (NSM Procedure) on page 522
The Adaptive Services (AS) and Multiservices PICs provide adaptive services interfaces,
which allow you to coordinate multiple services on a single PIC by configuring a set of
services and applications. The AS and Multiservices PICs offer a special range of services
you configure in one or more service sets.
To configure adaptive services PICS in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services.
3.
Select Adaptive Services.
4.
Add or modify the settings as specified in Table 258 on page 432.
5.
Click one:
6.
431