Configuring Bgp (Nsm Procedure); Table 320: Rpm Configuration Options - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Table 320: RPM Configuration Options

Option Function
Comment Supplies a descriptive comment for RPM. This is
optional.
Probe Limit Specifies the maximum number of concurrent probes
allowed.

Configuring BGP (NSM Procedure)

516
To configure the RPM feature:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the RPM feature.
Click the Configuration tab. In the configuration tree, select Services > Rpm.
3.
Select the Enable Feature check box.
4.
Configure the RPM options as specified in Table 320 on page 516.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the RPM options.
You can configure the following RPM options:
Configuring BGP (NSM Procedure) on page 516
Configuring Probe (NSM Procedure) on page 518
Configuring Probe Server (NSM Procedure) on page 521
This section provides information on configuring Border Gateway Protocol (BGP) for
RPM.
To configure BGP:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the BGP feature.
Click the Configuration tab. In the configuration tree, select Services > Rpm > Bgp.
3.
Configure the options as specified in Table 321 on page 517.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
Enter a comment.
Set the probe limit. Range: 1 through 500.
Copyright © 2010, Juniper Networks, Inc.