Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 126

M-series and MX-series Devices
90
Table 42: Multicast Snooping Options Configuration Details (continued)
Task
Establish multicast
snooping option values.
Configure tracing options.
Your Action
1. Click Option next to Multicast Snooping Options.
2. In the Comment box, enter the comments.
3. Expand Options.
4. Click Syslog next to Options.
5. In the Comment box, enter the comments.
6. From the Upto list, select the level up to which severity the
messages are to be syslogged.
7. From the Mark list, select the time interval in seconds to mark
the trace file.
Range : -2147483647 seconds to 2147483647 Seconds
Default : 0
8. Expand Syslog.
9. Click Level next to Syslog.
10. Select the Level of severity to be logged.
1. Click Traceoptions next to Multicast Snooping Options.
2. In the Comment box, enter the comments.
3. Expand Traceoptions.
4. Click File next to Trace Options.
5. In the Comment box, enter the comments.
6. In the Filename box, enter the name of the file to receive the
output of the tracing operation. Enclose the name within
quotation marks.
7. In the Size box, enter the maximum size of each trace file in
bytes.
Range : 10240 to 4294967295 bytes
8. From the Files list, select the maximum number of files.
9. Select one of the following:
world-readable—To enable log file access to all users.
no-world-readable—To prevent all users from reading the
log file.
10. Click Flag next to Trace Options.
11. Click Add new entry next to flag.
12. From the Name list, select a tracing operation to perform.
13. In the Comment box, enter the comments.
Copyright © 2010, Juniper Networks, Inc.