Table of Contents
Advertisement
Configuring Named Paths (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Table 169: Oam Configuration Details (continued)
Task
Configure MPLS tracing
options.
To configure signaled label switched paths (LSPs), you must first create one or more
named paths on the ingress router. For each path, you can specify some or all transit
routers in the path, or you can leave it empty. Each pathname can contain up to 32
characters and can include letters, digits, periods, and hyphens. The name must be unique
within the ingress router.
To configure named paths in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Mpls.
4.
Add or modify settings as specified in Table 170 on page 318.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Your Action
1.
Click Traceoptions next to Oam.
2. In the Comment box, enter the comment.
3. Select the No Remote Trace check box to disable remote
tracing globally or for a specific tracing operation.
4. Click File next to Traceoptions.
5. In the Filename box, enter the name of the file to receive the
output of the tracing operation.
6. In the Size box, enter the maximum size of each trace file, in
kilobytes (KB), megabytes (MB), or gigabytes (GB).
7. From the Files list, select the maximum number of trace files.
Range: 2 through 1000
8. Select one of the following:
world-readable—To enable unrestricted file access.
no-world-readable—To restrict file access to owner.
9. In the Match box, enter the regular expression.
10. Click Flag next to Traceoptions.
11. Click Add new entry next to Flag
12. From the Name list, select the flag.
13. In the Comment box, enter the comment.
Chapter 20: Configuring Protocols
317
Advertisement
Table of Contents
