Configuring Traceoptions (Nsm Procedure); Table 255: Traceoptions Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
Table 254: Source Configuration Details (continued)
Option Function
Comment Supplies a descriptive comment for the overflow
pool.
Pool > Overflow Pool > Pool Name
None Specifies that neither the pool-name nor the
interface option is enabled.
pool-name Specifies the overflow pool name.
interface Specifies the interface for the overflow pool.

Configuring Traceoptions (NSM Procedure)

Table 255: Traceoptions Configuration Details

Option
Comment
No Remote Trace
428
The traceoptions feature allows you to configure the file and the flag options.
To configure traceoptions:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the traceoptions.
Click the Configuration tab. In the configuration tree, select Security > Nat >
3.
Traceoptions.
Configure the options as specified in Table 255 on page 428.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the traceoptions settings.
Function
Supplies a descriptive comment for the
traceoptions.
Disables the remote tracing.
You can now configure the following options:
Configuring the File Options (NSM Procedure) on page 429
Configuring Flag Options (NSM Procedure) on page 429
Your Action
Enter a comment.
Select the option.
Select the option and enter the pool name.
Select the option.
Your Action
(Optional) Enter a comment.
Select the No Remote Trace check box to enable
this feature.
Copyright © 2010, Juniper Networks, Inc.