Configuring Vstp (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Table 201: VRRP Configuration Fields (continued)
Field
Startup Silent Period
Traceoptions

Configuring VSTP (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Function
Enables the system to ignore the Master
Down Event when an interface
transitions from the disabled state to the
enabled state. It avoids an incorrect error
alarm caused by delay or interruption of
incoming VRRP advertisement packets
during the interface startup phase.
Enables you to configure VRRP level
tracing options.
VLAN Spanning Tree Protocol (VSTP) is a spanning tree protocol which creates a
loop-free topology in VLANs. VSTP maintains a separate spanning tree instance for each
VLAN. Different VLANs can use different spanning tree paths and VSTP can support up
to 4094 different spanning tree topologies.
To configure VSTP in NSM:
In the navigation tree select
1.
list.
In the configuration tree, expand
2.
Select .
3. VSTP
Add/Modify the parameters under the respective tabs as specified in Table 202 on
4.
page 360.
Click one:
5.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply — To apply the protocol settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See Updating
Devices for more information.
Your Action
1. Expand the
VRRP
2. Enter the startup silent period or
select from the list
1. Expand the
2. Select
3. Select
4. Set up the file and flag parameters.
Device Manager > Devices
Protocols .
Chapter 20: Configuring Protocols
tree and select
Protocol
.
tree.
Protocol
and expand the tree.
VRRP
Traceoptions .
and select the device from the
359