Configuring Access; Chapter 7 Configuring Access; Configuring Address-Assignment Pools (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

CHAPTER 7

Configuring Access

Configuring Address-Assignment Pools (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Configuring Address-Assignment Pools (NSM Procedure) on page 49
Configuring Access Address Pools (NSM Procedure) on page 52
Configuring Access Group Profile (NSM Procedure) on page 53
Configuring the LDAP Options (NSM Procedure) on page 54
Configuring the LDAP Server (NSM Procedure) on page 55
Configuring Access Profiles for L2TP or PPP Parameters (NSM Procedure) on page 56
Configuring the RADIUS for Subscriber Access Management, L2TP, or PPP (NSM
Procedure) on page 70
Configuring the SecurID Server (NSM Procedure) on page 71
Configuring the Access Profile (NSM Procedure) on page 72
The address-assignment pool feature supports subscriber management functionality
by enabling you to create address pools that can be shared by different client applications.
An address-assignment pool can support either IPv4 address or IPv6 addresses. You
cannot use the same pool for both types of address.
To configure address assignment pools in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Access.
3.
Select Address Assignment.
4.
Add or modify settings as specified in Table 8 on page 50.
5.
Click one:
6.
OK-Saves the changes.
Cancel-Cancels the modifications.
49