Configuring The File Options (Nsm Procedure); Table 238: Traceoptions Configuration Details; Table 239: File Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Table 238: Traceoptions Configuration Details

Option
Comment
No Remote Trace

Table 239: File Configuration Details

Option Function
Comment Supplies a descriptive comment for the filename.
Filename Specifies the filename to write the traceoptions.
Size Specifies the maximum size of the trace file.
Files Specifies the maximum number of trace files.
None Specifies that neither the world-readable nor the
no-world-readable option is enabled.
world-readable Allows any user to read the log file.
no-world-readable Prevents any user from reading the log file.
Copyright © 2010, Juniper Networks, Inc.
Function
Supplies a descriptive comment for the
traceoptions.
Disables remote tracing.
You can now configure the following options:
Configuring the File Options (NSM Procedure) on page 407
Configuring Flag Options (NSM Procedure) on page 408

Configuring the File Options (NSM Procedure)

To configure file options:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the file options.
Click the Configuration tab. In the configuration tree, select Security > Ike >
3.
Traceoptions > File.
Configure the file options as specified in Table 239 on page 407.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the file settings.
Chapter 22: Configuring Security
Your Action
(Optional) Enter a comment.
Select the No Remote Trace check box.
Your Action
Enter a comment.
Enter a filename.
Enter the maximum file size.
Set the maximum number of trace files.
Range: 2 - 1000.
Select the option.
(Optional) Select the option.
(Optional) Select the option.
407