Table 212: Configuring Maximum Prefixes Fields - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Table 212: Configuring Maximum Prefixes Fields

Option
Comment
Limit
Log Interval
Threshold
376
In the navigation tree, select
1.
In the list, double-click the device to select it.
Devices
2.
Click the
3. Configuration
In the configuration tree, expand
4.
Select Maximum Prefixes
5.
Enter the parameters as specified in Table 212 on page 376.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the routing option settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the comment for the maximum
prefix limit.
Indicates the maximum number of route
prefixes. If this limit is reached, a warning
is triggered and additional routes are
rejected.
Indicates the minimum time interval (in
seconds) between log messages.
Specifies what is to be done when the
routing table reaches the maximum
prefix value. The options are:
None—No action is to be taken.
threshold—You can configure a
percentage for the maximum number
of prefixes, which when installed,
triggers the warning.
log-only—Sets the prefix limit as an
advisory limit. An advisory limit
triggers only a warning, and additional
routes are not rejected.
Device Manager > Devices
tab.
.
Routing Options
.
Your Action
Enter the comment.
Enter limit value or select from the list.
Enter the log interval value or select from
the list.
1.
2. Select the option button.
.
Expand the Maximum Prefixes
and select Threshold .
Copyright © 2010, Juniper Networks, Inc.
tree