Table of Contents
Advertisement
M-series and MX-series Devices
Related
Documentation
Comparing Device Inventory in NSM and the CLI
Viewing Device Inventory in NSM
Purpose
Action
568
For detailed information about comparing and reconciling device inventory, see the
Network and Security Manager Administration Guide.
Managing M-series and MX-series Device Software Versions on page 565
Comparing Device Inventory in NSM and the CLI on page 568
NSM and the JUNOS command-line interface (CLI) display similar information about
the device inventory, although screens rendered in NSM look different than the JUNOS
CLI. This topic provides an introduction to viewing software and hardware inventory using
NSM and compares the NSM view with the CLI output for the same device.
Viewing Device Inventory in NSM on page 568
Viewing Device Inventory from the CLI on page 570
NSM displays the hardware and software inventory for each device according to the
information it has in its database. For a device with dual Routing Engines, NSM collects
the inventory data from the master Routing Engine.
To view the device inventory, the device must be in the Managed state.
To view the device inventory, follow these steps:
In the navigation tree, select Device Manager > Devices.
1.
Right-click the device whose inventory you want to view.
2.
Select View/Reconcile Inventory.
3.
The Device Inventory window opens, similar to the example shown in Figure 7 on
page 568.
Figure 7: The Device Inventory Window
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
