Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 146

M-series and MX-series Devices
110
Table 49: Lcc Configuration Details (continued)
Task
Configure data used in a
hash key for the
multiservice protocol family
when configuring PIC-level
symmetrical hashing for
load balancing on an
802.3ad link aggregation
group.
Configure the channelized
T3 port number on the PIC.
Configure delay buffers.
Configure port-mirroring
instances for PIC.
Your Action
1. Click Multiservice next to Family.
2. In the Comment box, enter the comment.
3. Select the Source Mac check box to include source MAC
address in the hash key.
4. Select the Destination Mac check box to include destination
MAC address in the hash key.
5. Click Payload next to Multiservice.
6. Click Ip next to Payload.
7. In the Comment box, enter the comment.
8. Select the Layer 4 check box to include Layer 4 IP information
in the hash key.
9. Click Layer 3 next to Ip.
10. Select one of the following:
source-ip-only—To include source IP only in hash-key.
destination-ip-only—To include desintation IP only in
hash-key.
11. Click Symmetric Hash next to Multiservice.
12. In the Comment box, enter the comment.
13. Select the Complement check box to include the complement
of the symmetric hash in the hash key.
1. Click Add new entry next to Fpc.
2. Click Pic next to fpc.
3. Click Add new entry next to Pic.
4. Click Port next to pic.
5. From the Name list, select the port number.
6. In the Comment box, enter the comment.
7. From the Framing list, select the framing type.
1. Click Add new entry next to Fpc.
2. Click Pic next to fpc.
3. Click Add new entry next to Pic.
4. Click Q Pic Large Buffer next to pic.
5. In the Comment box, enter the comment.
1. Click Add new entry next to Fpc.
2. Click Pic next to fpc.
3. Click Add new entry next to Pic.
4. Click Port Mirror Instance next to pic and perform the following:
Add—Adds the selected port-mirroring instances from the
Non member list to the Members list.
Remove—Removes the selected port-mirroring instances
from the Members list.
Add All—Adds all the port-mirroring instances from the
Non-members list to the Members list.
Remove All—Removes all the port-mirroring instances from
the Members list.
Copyright © 2010, Juniper Networks, Inc.