Table 329: Configuring Community Fields - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Table 329: Configuring Community Fields

Option
Name
Comment
View
Authorization
Client List Name
Routing Instance
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Function
Specifies the name of the community.
Specifies the comment for the
community.
Specifies the view associated with the
community.
Specifies the type of access granted to
the community. Access is authorized for
SNMP Get, GetBulk, GetNext, and Set
requests.
Specifies a client list or prefix list to be
assigned to an SNMP community.
Specifies a routing instance for a
community.
Configuring Client Lists (NSM Procedure)
Chapter 24: Configuring SNMP
Your Action
Enter a name for the community.
Enter a comment.
Enter a name for the view.
Select an access type for the
community:
—No requests are enabled.
None
—Enable Get, GetNext, and
read-only
GetBulk requests. This option is
enabled by default.
—Enable all requests,
read-write
including Set requests.
You must configure a view to enable
Set requests.
1. Expand the tree and
Community
select .
Client List Name
2. Select a name.
1. Expand the tree and
Community
select .
Routing Instance
2. Click the New button or select an
entry and click the Edit button.
3. Configure the following to create and
define a routing instance:
—Enter a name for the
Name
routing instance.
NOTE: On routers, to configure a routing
instance within a logical system, specify
the logical system name followed by the
routing instance name. Use a slash ( / )
to separate the two names. To configure
the default routing instance on a logical
system, specify the logical system name
followed by "default."
Comment—Enter a comment for
the routing instance.
527