Configuring The Tcp Mss Option (Nsm Procedure); Table 227: Bridge Configuration Details; Table 228: Tcp Mss Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Table 227: Bridge Configuration Details

Option Function
Comment Supplies a descriptive comment for the bridge
option.
Block Non Ip All Specifies that all non-IP and non-ARP traffic,
including broadcast and multicast traffic are
blocked.
Bypass Non Ip Unicast Allows all non-IP traffic that includes unicast traffic.
Bridge > No Packet Flooding
Enable Feature Allows to enable the feature of setting the No Packet
Flooding.
Comment Supplies a descriptive comment for the packet
flooding option.
No Trace Route Specifies that the ICMP must not be sent to trigger
MAC learning.

Configuring the TCP MSS Option (NSM Procedure)

Table 228: TCP MSS Configuration Details

Option Function
Comment Supplies a descriptive comment for TCP MSS.
Tcp Mss > All Tcp
Comment Supplies a descriptive comment for the all TCP
options.
Copyright © 2010, Juniper Networks, Inc.
To configure the TCP MSS option:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the TCP MSS option.
Click the Configuration tab. In the configuration tree, select Security > Flow > Tcp
3.
Mss.
Configure the options as specified in Table 228 on page 395.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the TCP MSS settings.
Chapter 22: Configuring Security
Your Action
(Optional) Enter a comment.
Select the Block Non Ip All check box to
enable this feature.
Select the Bypass Non Ip Unicast check box
to enable this feature.
Select Enable Feature to enable this feature.
(Optional) Enter a comment.
Select the No Trace Route check box to
enable this feature.
Your Action
(Optional) Enter a comment.
(Optional) Enter a comment.
395