Configuring Snmp Communities (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
Related
Documentation

Configuring SNMP Communities (NSM Procedure)

526
Table 328: Basic System Identification Details (continued)
Option Function
Snmp > Engine Id
Use Mac Address Sets the engine ID to use the MAC
address.
Configuring SNMP Communities (NSM Procedure) on page 526
Configuring SNMP Trap Groups (NSM Procedure) on page 528
Configuring SNMP Views (NSM Procedure) on page 529
You can configure an SNMP community to authorize access to the SNMP server by SNMP
clients, based on the source IP address of incoming SNMP request packets. A community
also defines which MIB objects are available and the operations (read-only or read-write)
allowed on those objects. The SNMP client application specifies an SNMP community
name in Get, GetNext, GetBulk, and Set SNMP requests. If a community is not configured,
all SNMP requests are denied.
To configure SNMP communities in NSM:
In the navigation tree, select
1.
In the list, double-click the device to select it.
2. Devices
Click the
Configuration
3.
In the configuration tree, expand
4.
Select .
Community
5.
Click the Add or Edit icon.
6.
Enter the parameters as specified in Table 329 on page 527.
7.
Click one:
8.
OK —To save the changes.
—To cancel the modifications.
Cancel
Apply —To apply the SNMP settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Your Action
Select this option.
Device Manager > Devices
tab.
SNMP .
.
Copyright © 2010, Juniper Networks, Inc.