Table 119: Mpls Family Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Copyright © 2010, Juniper Networks, Inc.

Table 119: MPLS Family Configuration Details

Task
Configure MPLS
information.
Configure input filter.
Configure output filter.
Apply a policer to an
interface.
Your Action
1. Click Add Interface next to Interface.
2. In the Add Interface Dialog box, enter the interface name.
3. Click Unit next to interface.
4. Click Add new entry next to Unit.
5. Click Family next to Unit.
6. Expand Family.
7. Click MPLS next to Family.
8. In the Comment box, enter the comment.
9. From the Mtu list, select the MTU size.
Range: 0 through 4294967295
1. Click Input next to Filter.
2. Select one of the following:
input—To configure name of one filter to evaluate when
packets are received on the interface. Enter the input filter
name.
input-list—To apply a group of filters to evaluate when
packets are received on an interface.
a. Click Add new entry next to input-list.
b. In the New input-list window, enter the filter names. Up
to 16 filters can be included in a filter input list.
1. Click Output next to Filter.
2. Select one of the following:
output—To configure name of one filter to evaluate when
packets are transmitted on the interface. Enter the output
filter name.
output-list—To apply a group of filters to evaluate when
packets are transmitted on an interface.
a. Click Add new entry next to output-list.
b. In the New output-list window, enter the filter names.
Up to 16 filters can be included in a filter input list.
1. Click Policer next to Filter.
2. In the Comment box, enter the comment.
3. In the Input box, enter the name of one policer to evaluate when
packets are received on the interface.
4. In the Output box, enter the name of one policer to evaluate
when packets are transmitted on the interface.
Chapter 17: Configuring Interfaces
233