Configuring A Gateway (Nsm Procedure); Table 235: Gateway Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Configuring a Gateway (NSM Procedure)

Table 235: Gateway Configuration Details

Option Function
gateway
Name Specifies the gateway name.
Comment Supplies a descriptive comment for the
gateway.
Ike Policy Specifies the name of the IKE policy.
No Nat Traversal Disables the IPsec NAT traversal.
Nat Keepalive Specifies the time interval to send the
keepalives.
External Interface Specifies the external interface for the IKE
negotiations.
gateway > Address
address Specifies the address of the gateway.
402
Apply—Applies the IKE parameters.
You can now configure the following options:
Configuring a Gateway (NSM Procedure) on page 402
Configuring a Policy (NSM Procedure) on page 404
Configuring a Respond Bad SPI (NSM Procedure) on page 406
Configuring Traceoptions (NSM Procedure) on page 406
To configure the gateway option:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the gateway option.
Click the Configuration tab. In the configuration tree, select Security > Ike > Gateway.
3.
Add or modify settings as specified in Table 235 on page 402.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the gateway settings.
Your Action
Enter the gateway name.
(Optional) Enter a comment.
Select the IKE policy from the list.
Select the No Nat Traversal check box to enable this
feature.
Set the time interval. Range: 1 - 300.
Enter the external interface for the IKE negotiations.
Select the option and add or modify the address.
Copyright © 2010, Juniper Networks, Inc.