Specifying The Name Of A Group Of Dhcp Server Addresses For Use By The Extended Dhcp Relay Agent (Nsm Procedure); Table 95: Relay Option 82 Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Specifying the Name of a Group of DHCP Server Addresses for Use by the Extended DHCP Relay
Agent (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.

Table 95: Relay option 82 Configuration Details

Task
Enable or disable the
insertion of the DHCP relay
agent information option
(option 82) in DHCP packets
destined for a DHCP server.
You can specify the name of a group of DHCP server addresses for use by the extended
DHCP relay agent.
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Forwarding Options >
3.
DHCP Relay.
Select Server Group.
4.
Add or modify settings as specified in Table 96 on page 194.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Chapter 16: Configuring Forwarding Options
Your Action
1. Expand Relay Option 82.
2. In the Comment box, enter the comment for the relay option
82.
3. Click Circuit Id next to Relay Option 82.
4. In the Comment box, enter the comment.
5. Click Prefix next to Circuit Id.
6. In the Comment box, enter the comment.
7. Select the prefix to be added to the base option 82 agent circuit
ID information in DHCP packets destined for a DHCP server.
The prefix can consist of any combination of the hostname,
logical system name, and routing instance name.
193