Configuring The Authenticate Mechanism (Nsm Procedure); Table 310: Access Type Configuration Details; Table 311: Authenticate Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Table 310: Access Type Configuration Details

Option Function
Access Type > Wimax
None Specifies that neither the wimax or generic environment
is specified for the access type..
wimax Enables Worldwide Interoperability for Microwave
Access (WiMAX) environment.
generic Enables non-WiMAX environment.

Configuring the Authenticate Mechanism (NSM Procedure)

Table 311: Authenticate Configuration Details

Option Function
Comment Supplies a descriptive comment for the authenticate option.
This is optional.
Order Specifies the order in which to use the authenticate
mechanism.
506
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the access type options.
This section provides information on configuring authenticate mechanism for Mobile IP.
To configure the authenticate mechanism :
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the authenticate mechanism.
Click the Configuration tab. In the configuration tree, select Services > Mobile Ip >
3.
Authenticate.
Configure the authenticate options as specified in Table 311 on page 506.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the authenticate options.
Your Action
Select the option.
Select the option and enter a Comment in the
comment field.
Select the option and enter a Comment in the
comment field.
Your Action
Enter a comment.
Select an order from the list.
Copyright © 2010, Juniper Networks, Inc.