Table 117: Inet6 Family Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
226

Table 117: Inet6 Family Configuration Details

Task
Configure Inet6 information.
Enable IP packet counters on
an interface.
Your Action
1. Click Add Interface next to Interface.
2. In the Add Interface Dialog box, enter the interface name.
3. Click Unit next to interface.
4. Click Add new entry next to Unit.
5. Click Family next to Unit.
6. Expand Family.
7. Click Inet next to Family.
8. In the Comment box, enter the comment.
9. From the Mac Validate list, select one of the following:
strict—Forwards incoming packets when both the IP source
address and the MAC source address match one of the
trusted address tuples. Drops packets when the MAC
address does not match the tuple's MAC source address,
or when IP source address of the incoming packet does not
match any of the trusted IP addresses.
loose—Forwards incoming packets when both the IP source
address and the MAC source address match one of the
trusted address tuples. Drops packets when the IP source
address matches one of the trusted tuples, but the MAC
address does not match the MAC address of the tuple.
Continues to forward incoming packets when the source
address of the incoming packet does not match any of the
trusted IP addresses.
10. From the Mtu list, select the MTU size.
Range: 0 through 4294967295
11. Select the No Redirects check box to disable the sending of
protocol redirect messages for the entire routing platform.
12. Select the No Arp Learn check box to disable arp.
13. Select the Primary check box to configure the address to be
the primary address of the protocol on the interface.
1. Click Accounting next to Inet.
2. In the Comment box, enter the comment.
3. Select Destination Class Usage check box to enable packet
counters on an interface that count packets that arrive from
specific customers and are destined for specific prefixes on
the provider core router.
4. Click Source Class Usage next to Accounting.
5. In the Comment box, enter the comment.
6. Select the Input check box to configure at least one expected
ingress point.
7. Select the Output check box to configure at least one
expected egress point.
Copyright © 2010, Juniper Networks, Inc.