Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 140

M-series and MX-series Devices
104
Table 48: FPC Configuration Details (continued)
Task
Configure channelized T3
port and channel
specifications.
Configure data used in a
hash key for a protocol
family.
Configure data used in a
hash key for the inet
protocol family when
configuring PIC-level
symmetrical load balancing
on an 802.3ad link
aggregation group.
Your Action
1. Click Add new entry next to Fpc.
2. Click Pic next to fpc.
3. Click Add new entry next to Pic.
4. Click Ct3 next to pic.
5. In the Comment box, enter the comment.
6. Click Port next to Ct3.
7. Click Add new entry next to Port.
8. From the Name list, select the port number.
9. In the Comment box, enter the comment.
10. Click T1 next to Port.
11. Click Add new entry next to T1.
12. From the Name list, select the link number.
13. In the Comment box, enter the comment.
14. Click Channel Group next to t1.
15. Click Add new entry next to Channel Group.
16. From the Name list, select the channel number.
17. In the Comment box, enter the comment.
18. In the Timeslots box, enter the actual time slot number.
1. Click Add new entry next to Fpc.
2. Click Pic next to fpc.
3. Click Add new entry next to Pic.
4. Click Hash Key next to pic.
5. In the Comment box, enter the comment.
6. Click Family next to Hash Key.
7. In the Comment box, enter the comment.
1. Click Inet next to Family.
2. In the Comment box, enter the comment.
3. Click Layer 3 next to Inet.
4. In the Comment box, enter the comment.
5. Select the Destination Address check box to compute
symmetrical hashing based on the destination address.
6. Click Layer 4 next to Inet.
7. In the Comment box, enter the comment.
8. Click Symmetric Hash next to Inet.
9. In the Comment box, enter the comment.
10. Select the Complement check box to include the complement
of the symmetric hash in the hash key.
Copyright © 2010, Juniper Networks, Inc.