Configuring Cos Code Point Aliases (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
Related
Documentation

Configuring CoS Code Point Aliases (NSM Procedure)

126
Configuring CoS Code Point Aliases (NSM Procedure) on page 126
Configuring CoS Drop Profile (NSM Procedure) on page 127
Configuring CoS Forwarding Classes (NSM Procedure) on page 129
Configuring CoS Interfaces (NSM Procedure) on page 134
Configuring CoS Rewrite Rules (NSM Procedure)
Configuring CoS Schedulers (NSM Procedure) on page 141
Configuring CoS and Applying Scheduler Maps (NSM Procedure) on page 143
You can use code-point aliases to streamline the process of configuring CoS features on
your device. A code-point alias assigns a name to a pattern of code-point bits. You can
use this name instead of the bit pattern when you configure other CoS components such
as classifiers, drop-profile maps, and rewrite rules.
To configure code-point aliases:
In the navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure CoS code point aliases.
Click the Configuration tab. In the configuration tree, expand Class of Service.
3.
Select Code Point Aliases.
4.
Add or modify the settings as specified in Table 59 on page 127
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Network
and Security Manager Administration Guide for more information.
Copyright © 2010, Juniper Networks, Inc.