Configuring Providers; Configuring Resource Limits; Table 337: Provider Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Configuring Providers

Table 337: Provider Configuration Details

Option
Name
Comment
New deployment-scope

Configuring Resource Limits

542
Select Enable Feature check box to enable this feature.
4.
Enter a comment for the extensions feature.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the extensions parameters.
Configuring Providers on page 542
Configuring Resource Limits on page 542
To configure providers:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the providers.
Click the Configuration tab. In the configuration tree, select System > Extensions >
3.
Providers.
Add or modify settings as specified in Table 337 on page 542.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the provider settings.
Function
Specifies the provider name.
Supplies a descriptive comment for the provider.
Specifies the deployment scope.
To configure resource limits:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the resource limits.
Click the Configuration tab. In the configuration tree, select System > Extensions >
3.
Resource Limits.
Your Action
Enter a provider name.
(Optional) Enter a comment.
Enter a new deployment scope name.
Copyright © 2010, Juniper Networks, Inc.