Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 509

Copyright © 2010, Juniper Networks, Inc.
Table 281: Control Association Configuration Details (continued)
Task
Specify the method and
reason that the virtual BGF
includes in Notification
Messages or Registration
commands in ServiceChange
commands when a control
association transitions to
In-Service.
Configuring Virtual Interface Indications (NSM Procedure)
Virtual interface indications specify the method and reason that the virtual BGF includes
in ServiceChange commands that it sends to the gateway controller when the state of
the virtual interface changes.
To configure virtual interface indications in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp .
3.
Select Gateway.
4.
Add or modify the settings as specified in Table 282 on page 474.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.
Your Action
1. Click Up next to Control Association.
2. In the Comment box, enter the comment.
3. From the Failover Cold list, select the method and reason that
the virtual BGF includes in Registration ServiceChange
commands when it attempts to register with a new gateway
controller following a cold failover.
4. From the Failover Warm list, select the method and reason
that the virtual BGF includes in Registration ServiceChange
commands when it attempts to register with a new gateway
controller following a warm failover.
5. From the Cancel Graceful list, select the method and reason
that the virtual BGF includes in Notification ServiceChange
commands that it sends to the gateway controller when the
control association transitions from the Draining state to the
Forwarding state.
Chapter 23: Configuring Services
473