Table of Contents
Advertisement
M-series and MX-series Devices
344
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Ripng.
4.
Add or modify settings as specified in Table 192 on page 344.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 192: Import Policy Configuration Details
Task
Apply one or more policies
to routes being imported
into the local routing device
from the neighbors.
Configuring RIPng Update Messages (NSM Procedure)
You can enable and disable the receiving of update messages. By default, receiving
update messages is enabled.
To enable or disable the receiving update messages in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Ripng.
4.
Add or modify settings as specified in Table 193 on page 344.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 193: Receive Message Update Configuration Details
Task
Enable or disable the
receiving update messages.
Your Action
1.
Click Import Policy next to Neighbor.
2. Use the following options to select the policies to import:
Click Add after selecting a policy member from the Non
member list to add it to the Members list.
Click Remove after selecting a policy from the Members list
to remove it from the Members list.
Click Add All to add all the Non members to the Members
list.
Click Remove All to remove all the members from the
Members list.
Your Action
1.
Click Receive next to Neighbor.
2. In the Comment box, enter the comment.
3. Select the None check box to disable receiving update
messages.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
