Configuring Differentiated Services (Nsm Procedure); Configuring Event Timestamp Notification (Nsm Procedure); Table 285: Diffserv Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
478

Configuring Differentiated Services (NSM Procedure)

You can configure default values for properties in the Differentiated Services (DiffServ)
package using the Diffserv option.
To configure DiffServ in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp.
3.
Select Gateway.
4.
Add or modify the settings as specified in Table 285 on page 478.
5.
Click one:
6.
OK—To save the changes.
Cancel—To cancel the modifications.

Table 285: Diffserv Configuration Details

Task
Configure default values for
properties in the
Differentiated Services
(DiffServ) package.

Configuring Event Timestamp Notification (NSM Procedure)

You can enable or disable the gateway controller to access timestamp information for
media inactivity event notifications.
To configure event timestamp notification in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp .
3.
Select Gateway.
4.
Add or modify the settings as specified in Table 286 on page 479.
5.
Click one:
6.
Your Action
1. Click Add new entry next to Gateway.
2. Click H248 Properties next to gateway.
3. Expand H248 Properties.
4. Click Diffserv next to H248 Properties.
5. In the Comment box, enter the comment.
6. Click Dscp next to Diffserv.
7. In the Comment box, enter the comment.
8. From the Default list, select the default values for
Differentiated Services Code Point (DSCP) marking that the
virtual BGF uses for outgoing traffic when the DSCP value is
not already defined by the gateway controller.
Copyright © 2010, Juniper Networks, Inc.