Table 220: Traceoption Fields - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Table 220: Traceoption Fields

Option
Comment
File
Flag
388
In the navigation tree, select
1.
In the list, double-click the device to select it.
Devices
2.
Click the
3. Configuration
In the configuration tree, expand
4.
Select Traceoptions .
5.
Add or modify the parameters as specified in Table 220 on page 388.
6.
Click one:
7.
OK—To save the changes.
Cancel—To cancel the modifications.
Apply—To apply the routing option settings.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Updating
Devices section in the Network and Security Manager Administration Guide for
more information.
Function
Specifies the comment for the tracing
options.
Specifies the file to receive the output
of the tracing operation.
Specifies the global routing protocol
tracing options to be performed. You can
specify more than one option.
Device Manager > Devices
tab.
.
Routing Options
Your Action
Enter the comment.
1.
2. Enter the file parameters.
1.
2. Enter the flag parameters.
.
Expand the Traceoptions tree and
select File .
Expand the tree and
Traceoptions
select File .
Copyright © 2010, Juniper Networks, Inc.