Configuring Vpn Monitor Options (Nsm Procedure); Table 244: Vpn Monitor Options Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Table 243: VPN Configuration Details (continued)
Option
Service
vpn > Vpn Monitor
Enable Feature
Comment
Optimized
Source Interface
Destination Ip

Configuring VPN Monitor Options (NSM Procedure)

Table 244: VPN Monitor Options Configuration Details

Option Function
Comment Supplies a descriptive comment for the for the VPN
monitor options.
Interval Specifies (in seconds) the duration of monitoring
interval.
Copyright © 2010, Juniper Networks, Inc.
Function
Specifies the name of the service.
Allows to configure Vpn monitor.
Specifies a descriptive comment for the VPN
monitor.
Specifies that the VPN monitor is optimized for
scalability.
Specifies source interface for monitor messages.
Specifies destination IP address for monitor
messages.
To configure VPN monitor options:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the VPN monitor options.
Click the Configuration tab. In the configuration tree, select Security > Ipsec > Vpn
3.
Monitor Options.
Select the Enable Feature check box from the Vpn Monitor Options workspace.
4.
Add or modify settings as specified in Table 244 on page 413.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the VPN monitor options.
Chapter 22: Configuring Security
Your Action
Select the service from the list.
Select the Enable Feature check box to
enable this feature.
(Optional) Enter a comment.
Select the Optimized check box to enable
this feature.
Enter the source interface.
Enter the destination IP address.
Your Action
Enter a comment.
Set the interval duration. Range: 1 - 3600.
413