Configuring The Interface (Nsm Procedure); Table 251: Destination Nat Configuration Details; Table 252: Interface Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices

Table 251: Destination NAT Configuration Details

Option Function
destination-nat
Name Specifies a name for the destination NAT.
Comment Supplies a descriptive comment for the
destination NAT.
destination-nat > Address
None Specifies that neither the address nor the
address range is specified for the destination
NAT.
address Specifies the address of the destination NAT.
address-range Specifies the address range of the destination
NAT.

Configuring the Interface (NSM Procedure)

Table 252: Interface Configuration Details

Option
interface
422
To configure the interface:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the interface feature.
Click the Configuration tab. In the configuration tree, select Security > Nat > Interface.
3.
Add or modify the interface settings as specified in Table 252 on page 422.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the interface parameters.
Function
Your Action
Enter a name.
(Optional) Enter a comment.
Select the option.
Select the option and enter the following:
Comment—A descriptive comment for the destination
address.
Prefix—The address prefix.
Port—The port number. Range: 0 - 65535.
Select the option and enter the following:
Comment—A descriptive comment for the address
range.
Low—The lower limit of the address range.
High—The higher limit of the address range.
Your Action
Copyright © 2010, Juniper Networks, Inc.