Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
Table 179: MSDP Peer Configuration Details
Task
Configure MSDP peers.
Configure active source limit.
Apply one or more policies
to routes being exported
from the routing table into
MSDP.
Apply one or more policies
to routes being imported into
the routing table from MSDP.
Your Action
1.
Click Group next to Msdp.
2. Click Add new entry next to Group.
3. Click Peer next to group.
4. Click Add new entry next to Peer.
5. In the Name box, enter the name of the MSDP group.
6. In the Comment box, enter the comment.
7. From the Mode list, select the mesh groups.
8. Select the Disable check box to disable MSDP.
9. In the Local Address box, enter the IP address of the local end
of the connection.
10. Select the Default Peer check box to establish this peer as the
default MSDP peer and accept source-active messages from
the peer without the usual peer-reverse-path-forwarding
(peer-RPF) check.
11. In the Authentication Key box, enter the MD5 authentication
key.
1.
Click Active Source Limit next to Peer.
2. In the Comment box, enter the comment.
3. From the Maximum list, select the maximum number of active
source messages.
Range: 1 through 1,000,000
Default: 25,000
4. From the Threshold list, select the RED threshold for active
source messages.
Range: 1 through 1,000,000
Default: 24,000
1.
Click Export next to Peer.
2. Use the following options to select the policies to export:
Click Add after selecting a policy member from the Non
member list to add it to the Members list.
Click Remove after selecting a policy from the Members list
to remove it from the Members list.
Click Add All to add all the Non members to the Members
list.
Click Remove All to remove all the members from the
Members list.
1.
Click Import next to Peer.
2. Use the following options to select the policies to import:
Click Add after selecting a policy member from the Non
member list to add it to the Members list.
Click Remove after selecting a policy from the Members list
to remove it from the Members list.
Click Add All to add all the Non members to the Members
list.
Click Remove All to remove all the members from the
Members list.
Chapter 20: Configuring Protocols
327
Advertisement
Table of Contents
