Table of Contents
Advertisement
M-series and MX-series Devices
290
Table 148: LSP Configuration Details
Task
Configure label switched
path.
Your Action
1.
Click Add new entry next to Label Switched Path.
2. In the Name box, enter the name that identifies the LSP.
3. In the Comment box, enter the comment.
4. Select the Disable check box to disable the functionality of the
configured object.
5. Select the No Install To Address check box to prevent the
egress router address configured using the to statement from
being installed into the inet.3 and inet.0 routing tables.
6. Select the Backup check box to configure a backup provider
edge (PE) group for ingress PE router redundancy when
point-to-multipoint LSP are used for multicast distribution.
7. In the From box, enter the source address to use for the LSP.
8. Select the Ldp Tunneling check box to enable the LSP to be
used for LDP tunneling.
9. From the Metric list, select the LSP metric value
Default: No metric assigned (dynamic)
Range: 1 through 16,777,215
10. From the Retry Timer list, select the amount of time between
attempts to connect to the primary path.
Default: 30 seconds
Range: 1 through 600 seconds
11. From the Retry Limit list, select the maximum number of tries
to establish the primary path.
Default: 0 (The ingress node never stops trying to establish the
primary path.)
Range: 0 through 10,000
12. From the Revert Timer list, select the amount of time (in
seconds) that an LSP must wait before traffic reverts to a
primary path.
Default: 60 seconds
Range: 0 through 65,535 seconds
13. From the Class 0f Service list, select the CoS value.
Range: 0 through 7.
Default: If you do not specify a CoS value, the IP precedence
bits from the packet's IP header are used as the packet's CoS
value.
14. Select the No Decrement Ttl check box to disable normal
time-to-live (TTL) decrementing.
15. From the Hop Limit list, select the maximum number of hops.
Range: 2 through 255 (for an LSP); 0 through 255 (for fast
reroute)
Default: 255 (for an LSP); 6 (for fast reroute)
16. Select the No Cspf check box to disable constrained-path LSP
computation.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
