Table of Contents
Advertisement
M-series and MX-series Devices
Configuring MPLS Statistics (NSM Procedure)
320
Table 172: Static Path Configuration Details (continued)
Task
You can enable MPLS statistics collection and reporting using the Statistics option.
To configure static path in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Mpls.
4.
Add or modify settings as specified in Table 173 on page 321.
5.
Click one:
6.
Your Action
6. From the Push list, select the out-label value.
Range: 0 through 1,048,575
7. From the Double Push Bottom list, select the bottom-label
value.
Range: Labels 0 through 999,999 are for internal use. Labels
1,000,000 through 1,048,575 are unassigned by the JUNOS
Software and are available for static LSPs.
8. From the Double Push Top list, select the top-label value.
Range: Labels 0 through 999,999 are for internal use. Labels
1,000,000 through 1,048,575 are unassigned by the JUNOS
Software and are available for static LSPs.
9. From the Triple Push Bottom list, select the bottom-label
value.
Range: 0 through 1,048,575. Labels 0 through 999,999 are
for internal use. Labels 1,000,000 through 1,048,575 are
unassigned by the JUNOS Software and are available for static
LSPs.
10. From the Triple Push Middle list, select the middle-label value.
Range: 0 through 1,048,575. Labels 0 through 999,999 are
for internal use. Labels 1,000,000 through 1,048,575 are
unassigned by the JUNOS Software and are available for static
LSPs.
11. From the Triple Push Top list, select the top-label value.
Range: 0 through 1,048,575. Labels 0 through 999,999 are
for internal use. Labels 1,000,000 through 1,048,575 are
unassigned by the JUNOS Software and are available for static
LSPs.
12. From the Preference list, select the preference to be assigned
to the route.
13. From the Class Of Service list, select the CoS value.
Range: 0 through 7
Default: If you do not specify a CoS value, the IP precedence
bits from the packet's IP header are used as the packet's CoS
value.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
