Table of Contents
Advertisement
Configuring Service Filters for inet6 (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Table 85: Inet6 Firewall Filter Configuration Details (continued)
Task
To configure the service filters for inet6 in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Firewall > Family >
3.
Inet6.
Add or modify settings as specified in Table 86 on page 175.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 86: inet6 Service Filter Configuration Details
Task
Configure service filter.
Your Action
23. Click Accept next to Then.
24. Select one of the following:
—To accept a packet.
Accept
Discard
—To discard a packet silently, without sending an
ICMP message.
Next
—To evaluate the next term in the firewall filter.
25. Click Policer next to Then.
26. Select one of the following:
—To configure a new policer for each filter and select
policer
the policer name.
—To configure a tricolor marking policer,
three-color-policer
a. Expand Three Color Policer.
b. Click Single Rate next to Three Color Policer.
c. Select one of the following:
Select single-rate if the named tricolor policer is a
single-rate policer.
Select two-rate if the named tricolor policer is a
two-rate policer.
Your Action
1.
Click Service Filter next to inet.
2. Click Add new entry next to Service Filter.
3. Expand service-filter.
4. In the Name box, enter the name that identifies the service
filter.
Chapter 15: Configuring Firewall
175
Advertisement
Table of Contents
