Configuring A Source (Nsm Procedure); Table 253: Proxy Arp Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Table 253: Proxy ARP Configuration Details

Option Function
General
Comment Supplies a descriptive comment for the proxy ARP.
Interface > interface
Name Specifies the proxy ARP interface name.
Comment Supplies a descriptive comment for the proxy ARP
interface.
Interface > interface > Address
Name Specifies the proxy ARP address.
Comment Supplies a descriptive comment for the proxy ARP
interface address.
Interface > interface > Address > To
Comment Supplies a descriptive comment for the upper limit
of the address range.
Ipaddr Specifies the upper limit of the address range.

Configuring a Source (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Configure the options as specified in Table 253 on page 425.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the proxy ARP options.
To configure a source:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the source.
Click the Configuration tab. In the configuration tree, select Security > Nat > Source.
3.
Configure the options as specified in Table 254 on page 426.
4.
Click one:
5.
OK—Saves the changes.
Chapter 22: Configuring Security
Your Action
(Optional) Enter a comment.
Enter the proxy ARP interface name.
(Optional) Enter a comment.
Enter the proxy ARP interface address or
address range.
(Optional) Enter a comment.
(Optional) Enter a comment.
Enter the upper limit of the address range.
425