Specifying Address Family For Filters (Nsm Procedure); Table 98: Address Family Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Specifying Address Family for Filters (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Table 97: DHCP Relay Traceoptions Configuration Details (continued)
Task
Specify the name of the file
to receive the output of the
tracing operation and
specifies the maximum
number of trace files.
Specify the tracing operation
to perform. To specify more
than one tracing operation,
include multiple flag
statements.
You can specify address family for filters using this option. You can specify inet for IP
version 4 (IPv4), inet6 for IP version 6 (IPv6), mpls for MPLS, or vpls for virtual private
LAN service (VPLS).
To specify the address family for filters in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Forwarding Options >
3.
Family .
Add or modify settings as specified in Table 98 on page 195.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.

Table 98: Address Family Details

Task Your Action
Apply a forwarding 1.
table filter to a
2. Click Filter next to Inet, Inet6, or Mpls.
forwarding table.
3. In the Comment box, enter the comment.
4. From the Input list, select the name of the applied filter.
5. From the Output list, select the name of the applied filter.
Chapter 16: Configuring Forwarding Options
Your Action
1. Click File next to Traceoptions.
2. In the Comment box, enter the comment for the file.
3. In the Filename box, enter the name of the file to receive the
output of the tracing operation.
4. In the Size box, enter the maximum size of each trace file, in
kilobytes (KB), megabytes (MB), or gigabytes (GB).
5. From the Files list, select the maximum number of trace files.
Range: 2 through 1000.
6. Select one of the following:
world-readable—To enable unrestricted file access
no-world-readable—To restrict file access to owner
7. In the Match box, enter the regular expression.
1. Click Flag next to Traceoptions.
2. Click Add new entry next to Flag.
3. From the Name list, select the flag.
4. In the Comment box, enter the comment for the flag.
Click Inet, Inet6, or Mpls.
195