Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 185

Copyright © 2010, Juniper Networks, Inc.
Table 72: Translation Table Configuration Details (continued)
Task
Translate incoming IPv6 DSCP values to new
values.
Chapter 13: Configuring Class of Service Features
Your Action
1. Click To Dscp Ipv6 From Dscp Ipv6 next to
Translation Table.
2. Click Add new entry next to To Dscp Ipv6
From Dscp Ipv6.
3. In the Name box, enter the IPv6 DSCP
values
4. In the Comment box, enter the comment.
5. Click To Code Point next to
to-dscp-ipv6-from-dscp-ipv6.
6. Click Add new entry next to
to-dscp-ipv6-from-dscp-ipv6
7. From the Name list, select the DSCP.
8. In the Comment box, enter the comment.
9. Click From Code Points next to
to-code-point and perform the following:
Add—Adds the selected code points from
the Non member list to the Members list.
Remove—Removes the selected code
points from the Members list.
Add All—Adds all the code points from
the Non-members list to the Members
list.
Remove All—Removes all the code points
from the Members list.
149