Applying Policies To Routes Imported By Ripng (Nsm Procedure); Table 189: Ripng Export Policy Configuration Details; Table 190: Import Policy Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Network and security manager
Table of Contents

Advertisement

M-series and MX-series Devices
342

Table 189: RIPng Export Policy Configuration Details

Task
Apply a policy or list of
policies to routes being
exported to the neighbors.

Applying Policies to Routes Imported by RIPng (NSM Procedure)

To filter routes being imported by the local routing device from its neighbors, use the
Import option and list the names of one or more policies to be evaluated. If you specify
more than one policy, they are evaluated in order (first to last) and the first matching
policy is applied to the route. If no match is found, the local routing device does not import
any routes.
To apply export policies for RIPng in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Ripng.
4.
Add or modify settings as specified in Table 190 on page 342.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.

Table 190: Import Policy Configuration Details

Task
Apply one or more policies
to routes being imported
into the local routing device
from the neighbors.
Your Action
1.
Click Export next to Group.
2. Use the following options to select the policies to export:
Click Add after selecting a policy member from the Non
member list to add it to the Members list.
Click Remove after selecting a policy from the Members list
to remove it from the Members list.
Click Add All to add all the Non members to the Members
list.
Click Remove All to remove all the members from the
Members list.
Your Action
1.
Click Import next to Group.
2. Use the following options to select the policies to import:
Click Add after selecting a policy member from the Non
member list to add it to the Members list.
Click Remove after selecting a policy from the Members list
to remove it from the Members list.
Click Add All to add all the Non members to the Members
list.
Click Remove All to remove all the members from the
Members list.
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading

This manual is also suitable for:

M-seriesMx-series

Table of Contents