Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual page 481

Copyright © 2010, Juniper Networks, Inc.
Table 266: Transaction Policy Configuration Details (continued)
Task
Define the actions performed
on incoming requests that
match this policy.
Configure the next-hop
destination and egress
service point for a new
transaction policy.
Configuring a New Transaction Policy Set (NSM Procedure)
To configure a new transaction policy set in NSM:
Your Action
1. Click Then next to From.
2. In the Comment box, enter the comment.
3. Select the following check boxes:
accept—To accept the traffic and send it to its destination
reject—To reject the traffic and return a rejection message.
Rejected traffic can be logged or sampled.
trace—To trace messages accepted by this policy
4. In the Admission Control box, enter the controller name.
5. Click Message Manipulation next to Then.
6. In the Comment box, enter the comment.
7. Click Forward Manipulation next to Message Manipulation.
8. Click Add new entry next to Forward Manipulation.
9. In the Name box, enter the name of the forward message
manipulation rules that you want to add to your new
transaction policy.
10. In the Comment box, enter the comment.
11. Click Reverse Manipulation next to Message Manipulation.
12. Click Add new entry next to Reverse Manipulation.
13. In the Name box, enter the name of the reverse message
manipulation rules that you want to add to your new
transaction policy.
14. In the Comment box, enter the comment.
1. Click Route next to Then.
2. In the Comment box, enter the comment.
3. In the Egress Service Point box, enter the name of the service
point that you want to use as the egress service point.
4. Click Next Hop next to Route.
5. In the Comment box, enter the comment.
6. Click Address next to Next Hop.
7. Select the SIP entity towards which SIP requests are sent.
address—To configure the destination IPv4 address of the
next hop to contact
a. In the Comment box, enter the comment.
b. In the Ipv4 Address box, enter the destination IPv4
address of the next hop to contact.
c. From the Port list, select the destination port of the next
hop to contact. Default: 5060
d. Click Transport protocol next to Address.
e. In the Comment box, enter the comment.
f. Select the transport protocol for routing to the next hop.
request-uri—To route all requests and responses on the
dialog according to SIP.
Chapter 23: Configuring Services
445