Table 281: Control Association Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
472

Table 281: Control Association Configuration Details

Task
Specify the method and
reason that the virtual BGF
includes in Registration
Request ServiceChange
commands when it attempts
to reregister with the
gateway controller or
register with a new gateway
controller after the control
association is disconnected.
Specify the method and
reason that the virtual BGF
includes in Unregistration
Messages in ServiceChange
commands that it sends to
the gateway controller when
a control association
transitions to Out-of-Service
because of a failure.
Your Action
1. Click Add new entry next to Gateway.
2. Click H248 Options next to gateway.
3. Expand H248 Options.
4. Click Service Change next to H248 Options.
5. Expand Service Change.
6. Click Control Association Indications next to Service Change.
7. In the Comment box, enter the comment.
8. Expand Control Association Indications.
9. Click Disconnect next to Control Association Indications.
10. In the Comment box, enter the comment.
11. From the Reconnect list, select the method and reason that
the virtual BGF includes in Registration Request ServiceChange
commands when it attempts to reregister with the gateway
controller or register with a new gateway controller after the
control association is disconnected.
12. From the Controller Failure list, select the method and reason
that the virtual BGF includes in Registration Request
ServiceChange commands when it attempts to reregister with
the gateway controller or register with a new gateway controller
after the control association is disconnected.
1. Click Down next to Control Association.
2. In the Comment box, enter the comment.
3. From the Administrative list, select the method and reason
that the virtual BGF includes in Unregistration Messages in
ServiceChange commands that it sends to the gateway
controller when a control association transitions to
Out-of-Service because of an administrative operation.
4. From the Failure list, select the method and reason that the
virtual BGF includes in Unregistration or Notification Messages
in ServiceChange commands when a control association
transitions to Out-of-Service.
5. From the Graceful list, select the method and reason that the
virtual BGF includes in Notification ServiceChange commands
that it sends to the gateway controller when the control
association transitions from In-Service to
Out-of-Service-Graceful.
Copyright © 2010, Juniper Networks, Inc.