Configuring Mobile Ip (Nsm Procedure); Configuring Access Type (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Configuring Mobile IP (NSM Procedure)

Configuring Access Type (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
The Mobile IP feature allows you to configure the following options: access type,
authenticate, dynamic home assignment, home agent, peer, and traceoptions.
To configure the Mobile IP feature:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the Mobile IP feature.
Click the Configuration tab. In the configuration tree, select Services > Mobile Ip.
3.
Select the Enable Feature check box.
4.
Enter a comment in the Mobile IP workspace that describes the Mobile IP.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the Mobile IP settings.
You can now configure the following options:
Configuring Access Type (NSM Procedure) on page 505
Configuring the Authenticate Mechanism (NSM Procedure) on page 506
Configuring Dynamic Home Assignment (NSM Procedure) on page 507
Configuring the Home Agent (NSM Procedure) on page 507
Configuring the Peer (NSM Procedure) on page 510
Configuring Traceoptions (NSM Procedure) on page 513
This section provides information on configuring access type for Mobile IP.
To configure access type:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the access type option.
Click the Configuration tab. In the configuration tree, select Services > Mobile Ip >
3.
Access Type.
Enter a comment in the Access Type workspace that describes the access type.
4.
Configure the access type options as specified in Table 310 on page 506.
5.
Click one:
6.
Chapter 23: Configuring Services
505