Table of Contents
Advertisement
Related
Documentation
Configuring Access Group Profile (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Table 9: Access Address Pool Configuration Details
Task
Allocate IP addresses for
clients.
Configuring Address-Assignment Pools (NSM Procedure) on page 49
Configuring Access Group Profile (NSM Procedure) on page 53
You can configure the group profile to define the Point-to-Point Protocol (PPP) using
the Group Profile option.
To configure access group profile in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Access.
3.
Select Group Profile.
4.
Add or modify settings as specified in Table 10 on page 53.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 10: Access Group Profile Configuration Details
Task
Configure the group profile.
Your Action
1.
Click Address Pool next to Access.
2. Click Add new entry next to Address Pool.
3. In the Name box, enter the name to be assigned to an address
pool.
4. In the Comment box, enter the comment.
5. Click Address next to address-pool.
Select one of the following:
Select address to enter the address.
a. Enter the address.
Select address-range to configure the address range.
a. In the Low box, enter the lower limit of an address range.
b. In the High box, enter the upper limit of an address range.
Your Action
1.
Click Add new entry next to Group Profile.
2. In the Name box, enter the name to be assigned to the group
profile.
3. In the Comment box, enter the comment.
Chapter 7: Configuring Access
53
Advertisement
Table of Contents
