Table of Contents
Advertisement
M-series and MX-series Devices
310
Table 164: Bandwidth Configuration Details
Task
Configure an LSP as a
multiclass LSP.
Configuring BFD for MPLS IPv4 LSPs (NSM Procedure)
You can configure BFD for LSPs that use either LDP or RSVP as the signaling protocol
using the Oam option.
To configure BFD for LSPs in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols > Mpls.
3.
Select Label Switched Path.
4.
Add or modify settings as specified in Table 165 on page 310.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 165: Oam Configuration Details
Task
Enable OAM for
RSVP-signaled LSPs.
Your Action
1.
Click Add new entry next to Label Switched Path.
2. Click Secondary next to label-switched-path.
3. Click Add new entry next to Secondary.
4. Click Bandwidth next to secondary.
5. In the Comment box, enter the comment.
6. In the Per Traffic Class Bandwidth box, enter the bandwidth,
in bits per second.
7. In the Ct0 box, enter the bandwidth, for the specified class.
8. In the Ct1 box, enter the bandwidth, for the specified class.
9. In the Ct2 box, enter the bandwidth, for the specified class.
10. In the Ct3 box, enter the bandwidth, for the specified class.
Your Action
1.
Click Add new entry next to Label Switched Path.
2. Click Secondary next to label-switched-path.
3. Click Add new entry next to Secondary.
4. Click Oam next to secondary.
5. In the Comment box, enter the comment.
6. From the Lsp Ping Interval list, select the duration of the LSP
ping interval in seconds.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
