Configuring Auto Configuration (Nsm Procedure); Table 335: Arp Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Table 335: Arp Configuration Details

Option
Comment
Aging Timer
Passive Learning
Purging
Gratuitous Arp On Ifup
Gratuitous Arp Delay
System > Arp > Interfaces
Comment
System > Arp > Interfaces > Arp Interface
Name
Comment
Aging Timer
Related
Documentation

Configuring Auto Configuration (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Cancel—Cancels the modifications.
Apply—Applies the ARP configuration settings.
Function
Supplies a descriptive comment for the ARP.
Specifies the change in the ARP aging time value.
Specifies the ARP passive learning.
Specifies that the ARP purges when the link goes
down.
Specifies the gratuitous ARP announcement on
the interface up.
Specifies the delay in the gratuitous Arp request.
Supplies a descriptive comment for the interface.
Specifies the logical interface name for the ARP
interface.
Supplies a descriptive comment for the ARP
interfaces.
Specifies the change in the ARP aging time value.
Configuring Archival (NSM Procedure) on page 535
Configuring Accounting (NSM Procedure) on page 531
Configuring Auto Configuration (NSM Procedure) on page 537
To configure the auto configuration feature:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the auto configuration feature.
Chapter 25: Configuring System
Your Action
(Optional) Enter a comment.
Set the aging timer value. Range: 1 - 240.
Select the Passive Learning check box to
enable this feature.
Select the Purging check box to enable this
feature.
Select the Gratuitous Arp On Ifup check box
to enable this feature.
Set the gratuitous ARP delay value. Range:
-2147483648 - 2147483647.
(Optional) Enter a comment.
Enter an ARP interface name.
(Optional) Enter a comment.
Set the aging timer value. Range: 1 - 240.
537