Table of Contents
Advertisement
CHAPTER 11
Configuring Chassis
Configuring Aggregated Devices (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Configuring Aggregated Devices (NSM Procedure) on page 99
Configuring Chassis Alarms (NSM Procedure) on page 100
Configuring Container Interfaces (NSM Procedure) on page 101
Configuring Chassis FPC (NSM Procedure) on page 102
Configuring a T640 Router on a Routing Matrix (NSM Procedure) on page 107
Configuring Routing Engine Redundancy (NSM Procedure) on page 112
Configuring a Routing Engine to Reboot or Halt on Hard Disk Errors (NSM
Procedure) on page 113
The JUNOS Software supports the aggregation of physical devices into the defined virtual
links, such as the link aggregation of Ethernet interfaces defined by the IEEE 802.3ad
standard. You can configure the properties for Ethernet and sonet aggregated devices
on the router.
To configure the aggregated devices on the router:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Chassis > Aggregated
3.
Devices.
Add or modify the settings as specified in Table 45 on page 100.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
99
Advertisement
Table of Contents
