Documentation - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
Related

Documentation

30
The devices that you add to a device group must exist; that is, you must have previously
added or modeled the devices in the domain. You can group devices before configuring
them. You can add a device to more than one device group. You can also add a device
group to another device group.
NOTE: You cannot apply a template to a device group. You must apply
templates to individual devices in a device group. If you need to apply the
same set of templates to multiple devices, you can create a single template
that includes all the templates that are to be applied to a device, and then
apply the combined template to each device.
For an example of creating a device group, see "Adding Device Groups" in the Network
and Security Manager Administration Guide.
About Device Creation on page 25
Supported Add Device Workflows for M-series and MX-series Devices on page 26
Importing Devices Overview on page 27
Modeling Devices Overview on page 28
Adding Multiple Devices Using Automatic Discovery (JUNOS Software Devices Only)
on page 29
Copyright © 2010, Juniper Networks, Inc.