Configuring Cos And Applying Scheduler Maps (Nsm Procedure); Table 68: Assigning Forwarding Classes To Output Queues - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

Configuring CoS and Applying Scheduler Maps (NSM Procedure)

Table 68: Assigning Forwarding Classes to Output Queues

Task
Configure a scheduler map for
DiffServ CoS.
Configure a best-effort forwarding
class and scheduler.
Configure an expedited forwarding
class and scheduler.
Copyright © 2010, Juniper Networks, Inc.
You associate the schedulers with forwarding classes by means of scheduler maps. You
can then associate each scheduler map with an interface, thereby configuring the queues
and packet schedulers that operate according to this mapping.
To configure CoS and apply scheduler maps:
In the navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure CoS and apply scheduler maps.
Click the Configuration tab. In the configuration tree expand Class of Service.
3.
Select Scheduler Maps.
4.
Add or modify settings as specified in Table 68 on page 143.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
NOTE: After you make changes to a device configuration, you must push that
updated device configuration to the physical security device for those changes
to take effect. You can update multiple devices at one time. See the Network
and Security Manager Administration Guide for more information.
Action
1. Click Add new entry.
2. In the Name box, type the name of the scheduler map—for example,
diffserv-cos-map.
1. Select Forwarding Class and click Add new entry.
2. In the Name box, type the name of the previously configured best-effort forwarding
class—for example, be-class.
3. Select the previously configured best-effort scheduler—for example, be-scheduler.
4. Click OK.
1. Select Forwarding Class and click Add new entry.
2. In the Name box, type the name of the previously configured expedited forwarding
class—for example, ef-class.
3. Select the previously configured expedited forwarding scheduler—for example,
ef-scheduler.
4. Click OK.
Chapter 13: Configuring Class of Service Features
143