Table of Contents
Advertisement
Configuring Graceful Restart for RIPng (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Table 186: RIPng Configuration Details
Task
Configure RIPng.
You can configure graceful restart parameters specifically for RIPng using the Graceful
Restart option.
To configure graceful restart for RIPng in NSM:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device to select it.
2.
Click the Configuration tab. In the configuration tree, expand Protocols.
3.
Select Ripng.
4.
Add or modify settings as specified in Table 187 on page 339.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 187: Graceful Restart Configuration Details
Task
Configure graceful restart.
Your Action
1.
In the Comment box, enter the comment.
2. From the Metric In list, select the metric value.
Range: 1 through 15
Default: 1
3. From the Holddown list, select the estimated time to wait
before making updates to the routing table.
Range: 10 through 180 seconds
Default: 180 seconds
4. From the Route Timeout list, select the estimated time to wait
before making updates to the routing table.
Range: 30 through 360 seconds
Default: 180 seconds
5. From the Update Interval list, select the estimated time to wait
before making updates to the routing table.
Range: 10 through 60 seconds
Default: 30 seconds
Your Action
1.
Click Graceful Restart next to Ripng.
2. Select the Enable Feature check box to enable this option.
3. In the Comment box, enter the comment.
4. Select the Disable check box to disable the graceful restart.
5. From the Restart Time list, select the estimated time period
for the restart to finish.
Range: 1 through 600 seconds
Default: 60 seconds
Chapter 20: Configuring Protocols
339
Advertisement
Table of Contents
