Table of Contents
Advertisement
Related
Documentation
Configuring Helpers (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
Table 99: Load Balance Configuration Details
Task
Configure layer information
for the load-balancing
specification. Only the IPv4
protocol is supported.
Configure load balancing
based on MPLS labels. Only
the IPv4 protocol is
supported.
Configure load balancing
based on Layer 2 media
access control information.
Configuring Accounting Options (NSM Procedure) on page 185
Configuring Helpers (NSM Procedure) on page 197
Configuring Per-Flow and Per-Prefix Load Balancing (NSM Procedure) on page 205
You can enable Trivial File Transfer Protocol (TFTP) or Domain Name System (DNS)
request packet forwarding, or configure the router or interface to act as a Dynamic Host
Chapter 16: Configuring Forwarding Options
Your Action
1.
Click Inet next to Family.
2. Click Layer 3 next to Inet.
3. In the Comment box, enter the comment.
4. Select the Destination Address check box to include the
destination-address MAC information in the hash key.
5. Click Layer 4 next to Inet.
6. In the Comment box, enter the comment.
1.
Click Mpls next to Family.
2. Expand Mpls.
3. Click Payload next to Mpls.
4. In the Comment box, enter the comment.
5. Click Ip next to Payload.
6. In the Comment box, enter the comment.
7. Expand Ip.
8. Click Layer 3 Only next to Ip.
9. Select layer-3-only to include only Layer 3 IP information.
10. Select port-data to include the source and destination port
field information.
a. In the Comment box, enter the comment.
b. Select Source Msb to Include the most significant byte of
the source port.
c. Select Source Lsb to Include the least significant byte of
the source port.
d. Select Destination Msb to include the most significant byte
of the destination port.
e. Select Destination Lsb to Include the least significant byte
of the destination port.
1.
Click Multiservice next to Mpls.
2. In the Comment box, enter the comment.
3. Select Source Mac to include the source-address MAC
information in the hash key.
4. Select Destination Mac to include the destination-address MAC
information in the hash key.
197
Advertisement
Table of Contents
