Table of Contents
Advertisement
Copyright © 2010, Juniper Networks, Inc.
Configuring Differentiated Services (NSM Procedure) on page 478
Configuring Event Timestamp Notification (NSM Procedure) on page 478
Hanging Termination Detection (NSM Procedure) on page 479
Configuring Inactivity Timer (NSM Procedure) on page 480
Configuring Notification Behavior (NSM Procedure) on page 481
Configuring Segmentation (NSM Procedure) on page 482
Configuring Traffic Management (NSM Procedure) on page 483
Configuring Application Data Inactivity Detection (NSM Procedure)
You can activate or deactivate regulated notification of media inactivity events.
To configure application data inactivity detection in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
In the Configuration tab, expand Services > Pgcp.
3.
Select Gateway .
4.
Add or modify the settings as specified in Table 283 on page 475.
5.
Click one:
6.
OK—To save the changes
Cancel—To cancel the modifications
Table 283: Data Inactivity Detection Configuration Details
Task
Activate or deactivate
regulated notification of
media inactivity events.
Configuring Base Root (NSM Procedure)
You can configure default values for properties in the base root package using the Base
Root option:
To configure base root package in NSM:
In the navigation tree select Device Manager > Devices.
1.
In the Devices list, double-click the device to select it.
2.
Your Action
1.
Click Add new entry next to Gateway.
2. Click H248 Properties next to gateway.
3. In the Comment box, enter the comment.
4. Expand H248 Properties.
5. Click Application Data Inactivity Detection next to H248
Properties.
6. In the Comment box, enter the comment.
7. From the Ip Flow Stop Detection list, select the regulated or
non-regulated (immediate) notification of media inactivity
events.
Chapter 23: Configuring Services
475
Advertisement
Table of Contents
