Table of Contents
Advertisement
M-series and MX-series Devices
82
Table 37: Applications Configuration Details
Task
Configure properties of an
application and whether to
include it in an application
set.
Configuring application sets.
Your Action
1.
Click Application next to Applications.
2. Click Add new entry next to Application.
3. In the Name box, enter the identifier of the application.
4. In the Comment box, enter the comment.
5. From the Application Protocol list, select the name of the
protocol.
6. From the Protocol list, select the networking protocol type.
7. From the Source Port list, select the identifier for the port.
8. From the Destination Port list, select the Identifier for the port.
9. From the Snmp Command list, select the SNMP command
format.
10. From the Icmp Type list, select the ICMP packet type value.
11. From the Icmp Code list, select the Internet Control Message
Protocol (ICMP) code value.
12. From the Ttl Threshold list, select the TTL threshold value.
13. In the Rpc Program number box, enter the Remote procedure
call (RPC) or Distributed Computing Environment (DCE) value.
Range: 100,000 through 400,000
14. In the Uuid box, enter the Universal Unique Identifier (UUID)
for DCE RPC objects.
15. From the Inactivity Timeout list, select the length of time the
application is inactive before it times out.
16. Select the Learn Sip Register check box to activate SIP register
to accept potential incoming SIP calls.
17. From the Sip Call Hold Timeout list select the length of time
the application holds a SIP call open before it times out.
Default: 7200 seconds
Range: 0 through 36,000 seconds (10 hours)
18. Select one of the following:
do-not-translate-AAAA-query-to-A-query—To control the
translation of AAAA query to A query.
do-not-translate-A-query-to-AAAA—To control the
translation of A query to AAAA query.
1.
Click Application Set next to Applications.
2. Click Add new entry next to Application Set.
3. Expand application-set.
4. In the Name box, enter the identifier of an application set.
5. In the Comment box, enter the comment.
6. Click Application next to application-set.
7. Click Add new entry next to Application.
8. From the Name list, select the identifier of the application.
9. In the Comment box, enter the comment.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
