Configuring Unified Access Control (Nsm Procedure); Configuring Infranet Controller (Nsm Procedure); Table 325: Uac Configuration Details - Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1 Manual

M-series and MX-series Devices
Table 324: Probe Server Configuration Details (continued)
Option
Destination Interface

Configuring Unified Access Control (NSM Procedure)

Table 325: UAC Configuration Details

Option Function
Comment Specifies the comment for the UAC.
Timeout Specifies (in seconds) the timeout for the idle infranet
controller link.
Interval Specifies (in seconds) the heartbeat interval from the
infranet controller.
Timeout Action Specifies the action to be performed when an infranet
controller timeout occurs.
Test Only Mode Allows all traffic and log enforcement result.

Configuring Infranet Controller (NSM Procedure)

522
Function
Specifies the name of the output interface for
probes.
Unified Access Control (UAC) includes configuring infranet controllers and traceoptions.
To configure the UAC feature:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the device for which you want to
2.
configure the UAC feature.
Click the Configuration tab. In the configuration tree, select Services > Unified Access
3.
Control.
Configure the options as specified in Table 325 on page 522.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Apply—Applies the UAC options.
UAC includes configuring the following topics:
Configuring Infranet Controller (NSM Procedure) on page 522
Configuring Traceoptions (NSM Procedure) on page 523
This section describes how to configure infranet controller for UAC.
Your Action
Enter the name of the destination interface.
Your Action
Enter a comment.
Enter the timeout in seconds. Range: 2
through 4294967295.
Enter the heartbeat interval in seconds.
Range: 1 through 4294967295.
Select the timeout action.
Select the check box.
Copyright © 2010, Juniper Networks, Inc.